How to set up HP inkjets

Check diskless section in starting.mm again.

- Get table numbers with chapter
- building: introduction to first table
  	    space out the device entry descriptions

- X: how to swap keys

- overview of the releases

Man pages:

! - title width
! - Fx macro
! - csh ^ and friends

Check that chapter refs are still correct

Section on moving file systems.

Check the contents of the CD-ROMs.

On Wednesday, 12 June 2002 at  2:02:09 -0700, Annelise Anderson wrote:
> How then does the system know where the root partition is,

Normally it'll look in the a compatibility partition of the drive from
which you booted, but you can override it in /boot/loader.conf.  I
don't know if this is needed here, but I'll put it in my "to think
about" list.

> and what needs to be done in addition to the dump | restore?  (I
> have actually done this, having two almost identical systems in one
> machine on separate drives, each bootable, maintained in fairly
> close alignment with rsync, so I could boot either one (and fix the
> other if necessary)...Certainly /etc/fstab could not just be "copied
> over," but there was also some other stuff I dealt with.

There shouldn't be much else.

> In this regard it's also fairly common for people to want to take a
> disk from one computer and stick it in another, and they often have
> trouble with the disk getting read, being seen as the wrong disk,
> etc.  Especially with the IDE drives, where the CDROM is located
> seems to affect the BIOS/FreeBSD understand of whether a disk is ad1
> or ad2 or whatever. (Other chapters may deal with some of these
> difficulties.)

I don't understand the problem.  You mean the device naming?  I did
mention that in a SCSI context earlier on in this chapter, but in fact
IDE is simpler, since the numbers don't change.  I talk about the
device names in a different chapter.

--------------------------------------------------

> That's probably not going to do it for you. Put the following in
> /boot/loader.conf.local (create if needed) and reboot:
>
> hw.ata.ata_dma="1"
> hw.ata.atapi_dma="1"

FBSDU:  Page 617

Go through review drafts of before October.

Check IP addresses and domains (no LEMIS).
